Skip to main content

Vivo Y1s 2015 Flash File Dead Hang Logo 100 Te Hot Page

Vivo Y1S (2015 Model) Flash File: Complete Fix for Dead, Hang on Logo, and 100% TE Hot Issues

Published: Troubleshooting Guide for Service Centers & Advanced Users

If you own a Vivo Y1S (2015 edition)—often confused with the later Y1S (2020) model—and you are facing a dead device, a boot loop, a permanent hang on the logo, or the dreaded “100% TE Hot” error in your flashing tool, you have come to the right place. This comprehensive guide dives deep into the causes, solutions, and the exact flash file (firmware) needed to resurrect your device.

Note: The Vivo Y1S released in 2015 is powered by a Spreadtrum (Unisoc) SC7731 or similar chipset, unlike newer MediaTek variants. This guide is specifically for that older hardware. vivo y1s 2015 flash file dead hang logo 100 te hot

Pro Tip: Create a Backup of Your Current Firmware (If Phone is Alive)

If your phone only hangs on the logo but is detected by the PC:

  1. Use SPD Readback Tool to dump current firmware.
  2. Save the preloader partition – this can unbrick 100% dead phones later.

3. Prerequisites

To execute the restoration, the following tools and files are required: Vivo Y1S (2015 Model) Flash File: Complete Fix

  1. Flash Tool: QPST (Qualcomm Product Support Tools) or Vivo Official After-Sales Tool (AFTool).
  2. Drivers: Vivo USB Driver / Qualcomm USB Driver.
  3. USB Cable: Original or high-quality data cable.
  4. PC: Windows 7/10/11 (64-bit recommended).

Tools Required for Flashing

To successfully flash the Vivo Y1S (2015) and bypass the “TE hot” error, you need:

| Tool | Purpose | |------|---------| | SPD Upgrade Tool (Research Download) | Main flashing tool for Spreadtrum chips. Version: R19 or higher. | | SPD Driver Installer | USB VCOM drivers for Windows 7/8/10. | | USB Cable | High-quality, data-sync capable. | | Dead USB Dongle (optional) | To bypass “TE Hot” by resetting battery emulation. | Note: The Vivo Y1S released in 2015 is

6. Post-Flash Diagnostics

Once the tool confirms completion:

  1. Disconnect the USB cable.
  2. The device may not turn on immediately. Press and hold the Power button for 10-15 seconds.
  3. The Vivo logo should appear, followed by the boot animation.
  4. First Boot: The first boot after flashing may take 5-10 minutes. This is normal as the system configures cache and dalvik-cache.

2. 100% Logo Hang Removal

🧰 What You Would Get in Such a Feature (as a service or tool update)

| Feature | Benefit | |---------|---------| | One-click “Dead + Logo Hang” fix | No manual scatter selection | | Thermal-aware flashing | Prevents the “te hot” error | | Auto re-partition | Fixes wrong partition table (common cause of 100% hang) | | Log analyzer | Reads last_kmsg to confirm why logo hangs | | Firmware integrity check | Ensures the flash file isn’t corrupted (CRC32) |