V2000-c Rfid Access Control User Manual [exclusive]
The V2000-C RFID Access Control is a waterproof, standalone single-door system supporting up to 2,000 users with RFID card or PIN authentication. It features an adjustable relay for electronic locks, operating on 12V DC, with programming that includes setting user cards, PINs, and access modes. For official digital copies, you can access the Obohands English Manual Download from the manufacturer's site. RFID Access Control System User Manual - uAmper
Event Log & Audit
- Logs include: Card ID, user ID (if assigned), event type (access granted/denied), timestamp.
- Retrieve logs via:
- On-device USB/SD export (if available).
- PC software connection (serial/RS485/USB).
- Recommended: Regularly export and back up logs for security audits.
7. Troubleshooting (from manual)
| Problem | Likely cause | Solution |
|---------|--------------|----------|
| No power | Wrong voltage | Check 12V DC, min 1A |
| Card not beeping | Wrong RFID frequency | Use correct card type (125kHz EM) |
| Green LED but lock doesn’t open | Relay wiring wrong | Check NO/COM or NC/COM based on lock type |
| Buzzer long beep after card | User not enrolled | Add user via programming |
| Door open too long alarm | Door contact stuck | Adjust sensor position or disable with 04 0# | V2000-c Rfid Access Control User Manual
Maintenance
- Clean reader surface with a soft, damp cloth; avoid solvents.
- Inspect wiring and terminal connections periodically.
- Backup configuration and logs before firmware updates.
- Replace any damaged seals or enclosures to maintain weather resistance.
4.2 Wiring Diagram (Simplified)
| Controller Terminal | Connects To | | :--- | :--- | | 12V+ / GND | Power adapter (12V DC) | | NO / COM | Electric lock (Normally Open) | | NC / COM | Electric lock (Normally Closed) | | PUSH | Exit button (momentary switch) | | D-IN | Door contact/magnetic sensor | The V2000-C RFID Access Control is a waterproof,
⚠️ Do not apply AC mains directly to the relay terminals. Logs include: Card ID, user ID (if assigned),