Px-rc1 - Remote Control Manual
PX-RC1 Remote Control — Quick Manual
How to Pair / Sync a PX-RC1 (If Wireless)
Some newer PX-RC1s use 2.4GHz wireless (no line of sight required). If yours does not work out of the box:
- Insert fresh batteries into the remote.
- Power on your device (projector, light, slider).
- Locate the "Pair" button – On the remote, it is often a tiny pinhole near the bottom or under the battery cover. Use a paperclip to press and hold it for 3 seconds.
- On your device: Look for a "Remote Pair" option in the settings menu. Select it.
- The remote LED should blink then stay solid. Press "OK" to confirm.
🛈 If you do not see a pairing option: Your remote is Infrared (IR) . Just point and click – no pairing needed. px-rc1 remote control manual
Version A: The Projector Remote (Most Common)
- Look for: Power, Menu, Source, Volume (+/-), Keystone, OK/Enter.
- Used with: Mini projectors (eg, Piqo, VATM, or generic LED projectors).
- Key function: The red "Source" button switches between HDMI, USB, and AV.
Maintenance
- Clean with a soft, dry cloth. Do not use liquids or solvents.
- Avoid dropping or exposing to moisture/heat.
Problem 3: Works only from 1 foot away
- Diagnosis: Weak IR emitter. This is usually due to low battery voltage (even new batteries can be bad) or a cracked solder joint on the IR LED inside the remote.
- Fix: Open the remote (remove batteries, unscrew 1-2 small screws). Press the circuit board down gently. If it works, use a piece of tape to hold the board tight against the rubber buttons.
