K150 Pic Programmer Software Windows 10 High Quality <FULL ✔>

Because the K150 is an older, "generic" Chinese programmer, getting it to run on modern Windows requires specific drivers and a specific version of the software. It will not work with the newest Microchip tools (like MPLAB X).

For PIC16F & PIC18F (8-bit)

• MicroPro – A stripped-down version of the original software that sometimes works on Windows 10 if you replace the k150usb.sys with a modified signed version (community patches exist on EEVblog forums).

Chapter 3: The First Successful Flash

Alex inserted a PIC16F628A into the K150’s ZIF socket, pin 1 aligned top-left. Loaded blink.hex. Checked the “verify after programming” box. Pressed Write.

For one terrifying second, nothing happened. Then the progress bar moved. 5 seconds later: “Programming successful.” k150 pic programmer software windows 10

Alex plugged the PIC into a breadboard with an LED and resistor. Applied 5V. The LED blinked! Windows 10 had been conquered.

---

Part 2: The Software Landscape for K150 on Windows 10

When you search for "k150 pic programmer software windows 10" , you will find three primary software solutions. None of them are perfect, but one will work for you. Because the K150 is an older, "generic" Chinese

Step 5: If PICPGM Fails – Using WinPic800 + Zadig

Some users prefer WinPic800 because it has a better device database.

1. Download WinPic800 (version 3.64 or higher).
2. Install and run as Administrator.
3. Plug in K150. Open Zadig.
4. In Zadig, go to Options → List All Devices.
5. Select your K150 (may appear as “USB-SERIAL CH340” or “K150”).
6. Change the driver to libusb-win32 (not WinUSB).
7. Open WinPic800 → Settings → Programmer selection → Choose “K150”.
8. Go to Parallel port / USB selection → Choose the libusb option.
9. Test communication by clicking Identify Device. If it reads the device ID, success.

---

Abstract

This brief paper describes installing and using the K150 (K150 USB PIC Programmer) software on Windows 10 to program Microchip PIC microcontrollers. It covers driver installation, software setup, flashing firmware, common issues, and troubleshooting tips. MicroPro – A stripped-down version of the original

Troubleshooting Common Errors

• "Time out error" / "No K150 found":
  • Check your COM port number. The K150 software often only scans ports COM1 to COM4. If your adapter is on COM5 or higher, go to Device Manager > Right-click the adapter > Properties > Port Settings > Advanced, and change the COM port number to COM2 or COM3.
• "Programming Failed":
  • Ensure the chip is inserted correctly (Pin 1 indicator).
  • Ensure the chip is not code-protected already (you may need to "Erase" it first).
  • Check your power supply. Some USB ports do not supply enough current for the programmer; try a powered USB hub.

Step 3: Prepare Windows 10 for Unsigned Drivers (If Using Original K150.exe)

If you are stubborn and want the original K150 software, you must disable Driver Signature Enforcement. This is a security risk, but here is how:

1. Hold Shift and click Restart.
2. Go to Troubleshoot → Advanced Options → Startup Settings → Restart.
3. Press 7 or F7 for “Disable driver signature enforcement.”
4. Install the driver from the CD using have disk method in Device Manager.

Note: You must do this every boot or permanently disable Secure Boot in BIOS.