Iclass K9k9 Hd Pvr Compact Software 17 Install New! Guide
To install the version 17 software (or any firmware update) on your iClass K9K9 HD PVR Compact
, follow these steps. Please ensure you have a formatted USB drive (FAT32 is recommended) and do not power off the device during the process to avoid bricking the receiver. Installation Guide for iClass K9K9 HD PVR Compact Prepare the Software:
Download the specific firmware file (often ending in .bin or .sgn).
Copy the file directly to the root directory of your USB flash drive (don't put it in a folder). Connect the USB: iclass k9k9 hd pvr compact software 17 install
Plug the USB drive into the port on the front or back of your iClass receiver. Access the Update Menu: Press the Menu button on your remote.
Navigate to the Expansion or USB menu (this may vary slightly depending on your current firmware version). Select USB Menu or Software Update. Select the File:
Locate the software file you copied (e.g., K9K9_HD_PVR_V17.bin) and press OK. To install the version 17 software (or any
A prompt will appear asking if you want to update the software/firmware. Select Yes. Wait for Completion:
The receiver will display a progress bar. Do not touch the remote or turn off the power during this time.
Once finished, the device will typically reboot automatically. Factory Reset (Optional but Recommended): Device Not Detected : Check cables and try
To ensure the new software runs smoothly without bugs from old settings, go to Menu > Installation > Factory Default and select All. Note: This will erase your channel list. Important Notes
Version Verification: You can verify the installation success by going to Menu > System Information to check the current software version.
Safety: Only use software specifically designed for the "K9K9 HD PVR Compact" model; using software for the WiFi or LAN versions can cause system errors.
نرم افزار های آیکلاس – اردیبهشت 92 | نصاب باشی - اخبار ماهواره
6. Troubleshooting
| Issue | Likely Cause | Solution |
|--------|----------------|------------|
| “File not found” | USB not FAT32 / wrong file name | Reformat USB, rename file exactly as required (case-sensitive) |
| Stuck on boot logo | Interrupted update or corrupt file | Reinstall via forced recovery mode (repeat Step 3) |
| No PVR function after update | HDD not recognized | Go to PVR Settings → Format HDD (erases old recordings) |
| Remote not responding | IR profile changed in v17 | Use front panel buttons → System → Remote Control Type → Set to “Standard” |
Troubleshooting
- Device Not Detected: Check cables and try a different USB port or restart your computer and device.
- Installation Errors: Ensure you have administrative privileges, and check for any error codes online.
"No Signal" on previously working channels.
- Cause: Version 17 resets the DiSEqC 1.0 switching logic.
- Fix: Go to
Installation > DiSEqC 1.0. If you have a motor, revert to DiSEqC 1.2 and recalibrate your satellite positions. (Note: V17 remembers motor positions better than V15).
