Log in Sign up
Cart (0)

Hys3c210-cs Power Supply | 2025-2027 |

HYS3C210-CS is a specific internal power supply unit (PSU) primarily used in Harman Kardon audio equipment, such as the HKTS 200 subwoofer

. It is a multi-rail power supply designed to provide the specific high and low voltages required for amplifier circuits and control boards. Key Technical Specifications

While official standalone datasheets are rare, community repair and service data indicate the following typical outputs for this unit: Main Rail: 48V DC (Used to power the primary power amplifier). Secondary Rails:

±7V DC (Dual-rail output used for pre-amp or control logic). Form Factor: hys3c210-cs power supply

Internal open-frame or enclosed module board, often paired with an LFMA 00690 amplifier board. Common Use Cases & Issues Device Compatibility:

Found in various Harman Kardon home theater subwoofer models like the HKTS200 and potentially similar series. Common Failure: A frequent issue reported by users is the loss of the 48V output

, which prevents the subwoofer from producing sound even if the main unit powers on (indicated by the functioning ±7V rails). Repair vs. Replacement: HYS3C210-CS is a specific internal power supply unit

Because exact HYS3C210-CS replacements can be difficult to find, some users opt to simulate the rails

using a standard 48V supply and separate voltage regulators for the 7V lines. Service Resources Schematics:

You can find related technical documents and PSU schematic guides on platforms like With load disconnected

, which hosts service manuals for similar Harman Kardon PSU models. or instructions on how to troubleshoot a faulty unit?

3. Build Quality & Design

  • Enclosure: Perforated metal case for heat dissipation; screw-terminal input/output connections.
  • Components: Uses 105°C-rated electrolytic capacitors, EMI filter, and a thermally controlled fan.
  • PCB Layout: Clean separation between primary (high-voltage) and secondary (low-voltage) sides for safety.
  • Certifications: Typically CE, RoHS, and UKCA compliant.

4.1 Voltage Regulation

Maintains output within ±1% from 10% to 100% load – suitable for sensitive electronics.

Step 4: Power-Up Testing

  1. Without any load, turn on the input power. Measure output voltage (should be within ±2% of nominal).
  2. Connect a dummy load (e.g., a power resistor) at 50% rated current. Monitor voltage for sag.
  3. Check ripple with an oscilloscope (AC coupling, 20MHz bandwidth limit). Ensure it’s under 150mV.

Step 2 – AC Input Wiring

  • Turn off mains supply.
  • Connect L (live), N (neutral), and ⏚ (earth/ground).
  • Earth connection is mandatory for safety and EMI reduction.

Step 4 – Voltage Adjustment (if needed)

  • With load disconnected, power on the unit.
  • Turn the “Adj.” potentiometer using a small screwdriver.
    • Clockwise = increase voltage.
    • Counter-clockwise = decrease.
  • Typical adjustment range: ±10% of rated voltage.